E-1012
Fault image coming soon
E-1012Error code
Probe not detected
The system fails to detect a connected ultrasound probe or reports it as incompatible.
Possible cause: Faulty connector, broken cable or a fault on the probe interface board.
GE Healthcare
Logiq eError messages & error codes
Is your GE Healthcare Logiq e showing an error message? Here are the known error codes for this device with meaning, cause and fault image. You can have the fault fixed by us, manufacturer-independently.
- Manufacturer-independent
- Test report & warranty
- 1 to 2 working days
- Loan unit on request
Error-code library
Documented error messages for this device
3 known error messages, each with meaning, possible cause and fault image. The library keeps growing, so do check back.
E-4044
Fault image coming soon
E-4044Error code
Image artefact / channel failure
Streaks, dead zones or artefacts appear in the ultrasound image as individual channels fail.
Possible cause: Faulty beamformer channels or a crystal defect in the probe.
E-0007
Fault image coming soon
E-0007Error code
System start-up hangs
The system stalls during boot-up or restarts repeatedly.
Possible cause: A software or storage fault, or a defect on the mainboard.
Is your Logiq e showing one of these messages?
Send us a photo of the screen, ideally via WhatsApp. We'll match the fault to the component, give you a realistic estimate upfront and tell you what to do. Manufacturer-independent, with test report and warranty.
A photo says more than a thousand words.
A photo of the message is enough, we take care of the diagnosis, straightforward and personal.
Included with every repair
Manufacturer-independent and at component level, from the first diagnosis to the tested device back with you.
Manufacturer-independent & component-level
Test report and warranty
Usually 1 to 2 working days
Loan unit on request